3Com S7902E Command Reference Manual - page 1817
1-1
1
802.1X Configuration Commands
802.1X Configuration Commands
display dot1x
Syntax
display dot1x
[
sessions
|
statistics
] [
interface interface-list
]
View
Any view
Default Level
1: Monitor level
Parameters
sessions
: Displays 802.1X session information.
statistics
: Displays 802.1X statistics.
interface interface-list
: Specifies an Ethernet port list, which can contain multiple Ethernet ports. The
interface-list
argument is in the format of
interface-list
= {
interface-type
interface-number
[
to
interface-type
interface-number
] } & , where
interface-type
represents the port type,
interface-number
represents the port number, and & means that you can provide up to 10 port
indexes/port index lists for this argument. The start port number must be smaller than the end number
and the two ports must be of the same type.
Description
Use the
display dot1x
command to display information about 802.1X.
If you specify neither the
sessions
keyword nor the
statistics
keyword, the command displays all
information about 802.1X, including session information, statistics, and configurations.
Related commands: reset dot1x statistics, dot1x, dot1x retry, dot1x max-user, dot1x port-control, dot1x
port-method, dot1x timer.
Examples
# Display all information about 802.1X.
Equipment 802.1X protocol is enabled
CHAP authentication is enabled
Proxy trap checker is disabled
Proxy logoff checker is disabled
EAD quick deploy is enabled
Configuration: Transmit Period 30 s, Handshake Period 15 s