3Com S7902E Command Reference Manual - page 1570
1-38
Parameters
value
: Length of time for the Hello timer, in the range 1 to 65535 seconds.
Description
Use the
mpls ldp timer hello-hold
command to set a Hello timer.
Use the
undo mpls ldp timer hello-hold
command to restore the default.
In interface view, you can set the link Hello timer; in MPLS LDP remote peer view, you can set the
targeted Hello timer.
By default, the value of the link Hello timer is 15 seconds, and that of the targeted Hello timer is 45
seconds.
Changing the values of the Hello timers does not affect any existing session.
Related commands:
mpls ldp
(system view),
mpls ldp
(interface view).
Examples
# Set the link Hello timer to 100 seconds on interface VLAN-interface 1.
[Sysname] interface vlan-interface 1
[Sysname-Vlan-interface1] mpls
[Sysname-Vlan-interface1] mpls ldp
[Sysname-Vlan-interface1] mpls ldp timer hello-hold 100
# Set the targeted Hello timer to 1000 seconds.
[Sysname] mpls ldp remote-peer BJI
[Sysname-mpls-ldp-remote-bji] remote-ip 3.3.3.3
[Sysname-mpls-ldp-remote-bji] mpls ldp timer hello-hold 1000
mpls ldp timer keepalive-hold
Syntax
mpls ldp timer keepalive-hold value
undo mpls ldp timer keepalive-hold
View
Interface view, MPLS LDP remote peer view
Default Level
1: Monitor level