3Com S7902E Command Reference Manual - page 2313
1-20
vrrp ipv6 ping-enable
Syntax
vrrp ipv6 ping-enable
undo vrrp ipv6 ping-enable
View
System view
Default Level
2: System level
Parameters
None
Description
Use the
vrrp ipv6 ping-enable
command to configure a VRRP group to respond to the ping packets
destined for its virtual IPv6 address.
Use the
undo vrrp ipv6 ping-enable
command to disable a VRRP group from responding to the ping
packets destined for its virtual IPv6 address.
By default, a VRRP group responds to the ping packets destined for its virtual IPv6 address.
Perform this configuration before configuring a VRRP group.
Examples
# Configure a VRRP group to respond to the ping packets destined for its virtual IPv6 address.
[Sysname] vrrp ipv6 ping-enable
vrrp ipv6 vrid preempt-mode
Syntax
vrrp ipv6 vrid virtual-router-id preempt-mode
[
timer delay delay-value
]
undo
vrrp ipv6 vrid virtual-router-id preempt-mode
[
timer delay
]
View
Interface view
Default Level
2: System level
Parameters
virtual-router-id
:
Virtual router ID or VRRP group number, in the range 1 to 255.
timer delay delay-value
: Sets preemption delay. The
delay-value
argument is in the range of 0 to 255
seconds and defaults to 0 seconds.