3Com S7902E Command Reference Manual - page 761
1-29
Field
Description
Total Nets
Total networks
Intra Area
Total intra-area routes
Inter Area
Total inter-area routes
ASE
Total ASE routes
NSSA
Total NSSA routes
display ospf vlink
Syntax
display ospf
[
process-id
]
vlink
View
Any view
Default Level
1: Monitor level
Parameters
process-id
: OSPF process ID, in the range 1 to 65535.
Description
Use the
display ospf vlink
command to display OSPF virtual link information.
If no OSPF process is specified, the OSPF virtual link information of all OSPF processes is displayed.
Examples
# Display OSPF virtual link information.
OSPF Process 1 with Router ID 3.3.3.3
Virtual Links
Virtual-link Neighbor-ID -> 2.2.2.2, Neighbor-State: Full
Interface: 10.1.2.1 (Vlan-interface1)
Cost: 1562 State: P-2-P Type: Virtual
Transit Area: 0.0.0.1
Timers: Hello 10 , Dead 40 , Retransmit 5 , Transmit Delay 1
Table 1-16 display ospf vlink
command output description
Field
Description
Virtual-link Neighbor-id
ID of the neighbor connected to the router via the virtual link
Neighbor-State
Neighbor State: Down, Init, 2-Way, ExStart, Exchange, Loading, Full.
Interface
Local interface’s IP address and name of the virtual link
Cost
Interface route cost