3Com S7902E Command Reference Manual - page 176
1-13
Transmit delay : 2s
Trap interval : 5s
Fast start times : 3
Port 97 [GigabitEthernet2/0/1]:
Port status of LLDP : Enable
Admin status : Tx_Rx
Trap flag : No
Roll time : 0s
Number of neighbors: 1
Number of MED neighbors : 0
Number of CDP neighbors : 0
Number of sent optional TLV : 22
Number of received unknown TLV : 0
Table 1-4 display lldp status
command output description
Field
Description
Global status of LLDP
Indicating whether or not LLDP is globally
enabled
The current number of LLDP neighbors
Total number of the LLDP neighbor devices
The current number of CDP neighbors
The current number of CDP neighbors
LLDP neighbor information last changed time
The last changed time of LLDP neighbor
information
Transmit interval
Interval to send LLDPDU
Hold multiplier
TTL multiplier
Reinit delay
Initialization delay
Transmit delay
Delay period to send LLDPDUs
Trap interval
Interval to send traps
Fast start times
Number of the LLDPDUs to be sent
successively when a new neighboring device
is detected
Port number
interface-type interface-number
Port
LLDP
status
Port status of LLDP
Indicates whether or not LLDP is enabled on
the port.
Admin status
LLDP mode of the port, which can be:
z
TxRx. A port in this mode sends and
receives LLDPDUs.
z
Rx_Only. A port in this mode receives
LLDPDUs only.
z
Tx_Only. A port in this mode sends
LLDPDUs only.
z
Disable. A port in this mode does not send
or receive LLDPDUs.
Trap Flag
Indicates whether or not trap is enabled.
Roll time
LLDP polling interval. A value of 0 indicates
LLDP polling is disabled.