3Com S7902E Command Reference Manual - page 1477
1-7
undo last-listener-query-interval
View
MLD-Snooping view
Default Level
2: System level
Parameters
interval
: MLD last listener query interval in units of seconds, namely the length of time the device waits
between sending MLD multicast-address-specific queries. The effective range is 1 to 5.
Description
Use the
last-listener-query-interval
command to configure the MLD last listener query interval
globally.
Use the
undo last-listener-query-interval
command to restore the system default.
By default, the MLD last listener query interval is 1 second.
This command works only on MLD Snooping–enabled VLANs, but not on VLANs with MLD enabled on
their VLAN interfaces.
Related commands:
mld-snooping
last-listener-query-interval
.
Examples
# Set the MLD last listener query interval to 3 seconds globally.
[Sysname] mld-snooping
[Sysname-mld-snooping] last-listener-query-interval 3
max-response-time (MLD-Snooping view)
Syntax
max-response-time interval
undo max-response-time
View
MLD-Snooping view
Default Level
2: System level
Parameters
interval
: Maximum response time for MLD general queries, in units of seconds. The effective range is 1
to 25.
Description
Use the
max-response-time
command to configure the maximum response time for MLD general
queries globally.