3Com S7902E Command Reference Manual - page 1760
1-19
Parameters
idle-cut
{
disable
|
enable
}: Specifies local users with the idle cut function disabled or enabled.
service-type
: Specifies the local users of a type.
z
ftp
refers to users using FTP;
z
lan-access
refers to users accessing the network through an Ethernet, such as 802.1X users;
z
ssh
refers to users using SSH;
z
telnet
refers to users using Telnet;
z
terminal
refers to users logging in through the console port, AUX port.
state
{
active
|
block
}: Specifies all local users in the state of active or block. A local user in the state of
active can access network services, while a local user in the state of blocked cannot.
user-name
user-name
: Specifies all local users using the specified username. The username is a
case-sensitive string of 1 to 55 characters and does not contain the domain name.
vlan
vlan-id
: Specifies all local users in a VLAN. The VLAN ID ranges from 1 to 4094.
slot
slot-number
: Specifies all local users in the slot where the interface card is inserted.
Description
Use the
display local-user
command to display information about specified or all local users.
Related commands:
local-user
.
Examples
# Display the information of local user
bbb
on the card installed on slot 1.
Slot: 0
The contents of local user bbb:
State: Active
ServiceType: lan-access
Idle-cut: Disable
Access-limit: Enable Current AccessNum: 100
Bind location: Disable
Vlan ID: Disable
IP address: Disable
MAC address: Disable
FTP Directory: flash:
User Privilege: 0
Total 1 local user(s) matched.
Table 1-3 display local-user
command output description (for distributed device)
Field
Description
Slot
Slot number of the card
State
Status of the local user, active or block
ServiceType
Service types that the user can use, including ftp,
lan-access, ssh, telnet, and terminal.
Idle-cut
Whether idle cut is enabled
Access-limit
Access user connection limit