3Com S7902E Command Reference Manual - page 257
1-5
qinq ethernet-type service-tag
Syntax
qinq ethernet-type
service-tag
hex-value
undo qinq ethernet-type service-tag
View
Ethernet port view, Layer-2 aggregate interface view, port group view
Default Level
2: System level
Parameters
hex-value
: Hexadecimal protocol type ID, in the range of 0x0001 to 0xFFFF except the protocol type
values listed in
Table 1-1
.
Description
Use the
qinq ethernet-type service-tag
command to configure the TPID value of the service provider
network VLAN tags.
Use the
undo qinq ethernet-type service-tag
command to restore the default.
By default, the TPID value of the service provider network VLAN tags is 0x8100.
Examples
# Set the TPID value of the service provider network VLAN tags to 0x9100 for GigabitEthernet 2/0/1.
[Sysname] interface GigabitEthernet2/0/1
[Sysname-GigabitEthernet2/0/1] qinq ethernet-type service-tag 9100
qos apply policy
Syntax
qos apply policy policy-name
inbound
undo qos apply policy
inbound
View
Ethernet port view, port group view
Default Level
2: System level
Parameters
inbound
: Applies the specified policy to the traffic received on the current port(s).
policy-name
: Policy name, a string of 1 to 31 characters.
Description
Use the
qos apply policy
command to apply a policy on a port or a port group.