3Com S7902E Command Reference Manual - page 1409
1-38
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] pim ipv6 timer hello 40
pim ipv6 timer join-prune
Syntax
pim ipv6 timer join-prune
interval
undo pim ipv6 timer join-prune
View
Interface view
Default Level
2: System level
Parameters
interval
: Join/prune interval in seconds, with an effective range of 1 to 2,147,483,647.
Description
Use the
pim ipv6 timer join-prune
command to configure on the current interface the interval at which
join/prune messages are sent.
Use the
undo pim ipv6 timer join-prune
command to restore the system default.
By default, the join/prune interval is 60 seconds.
Related commands:
timer join-prune
.
Examples
# Set the join/prune interval to 80 seconds on VLAN-interface 100.
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] pim ipv6 timer join-prune 80
pim ipv6 triggered-hello-delay
Syntax
pim ipv6 triggered-hello-delay
interval
undo pim ipv6 trigged-hello-delay
View
Interface view
Default Level
2: System level
Parameters
interval
: Maximum delay in seconds between hello messages, with an effective range of 1 to 5.