3Com S7902E Command Reference Manual - page 2188
1-15
View
System view
Default Level
2: System level
Parameters
dir-name
: The name of the directory where a log file is saved, a string of 1 to 64 characters.
Description
Use the
info-center logfile switch-directory
command to configure the directory where a log file is
saved. Ensure that the directory is created first before saving a log file into it.
By default, the directory to save a log file is the logfile directory under the root directory of the storage
device. For a device supporting CF partition, the directory to save a log file is the logfile directory in the
second partition of the storage device.
Note that this command can be used to configure the directory to which a log file can be saved. The
configuration will lose after system restart or active/standby switchover of the main control boards.
Examples
# Create a directory with the name
test
under flash root directory.
%Created dir flash:/test.
# Set the directory to save the log file to flash:/test.
[Sysname] info-center logfile switch-directory flash:/test
info-center loghost
Syntax
info-center loghost
host
-
ip
[
channel
{
channel
-
number
|
channel
-
name
}
|
facility
local
-
number
] *
undo info-center loghost
host
-
ip
View
System view
Default Level
2: System level
Parameters
host
-
ip
: The IP address of the log host.
channel
: Specifies the channel through which system information can be output to the log host.
channel
-
number
: Specifies a channel number, in the range 0 to 9.
channel
-
name
: Specifies a channel name, which could be a default name or a self-defined name. The
user needs to specify a channel name first before using it as a self-defined channel name. For more
information, refer to the
info-center channel name
command.