3Com S7902E Command Reference Manual - page 2317
1-24
vrrp ipv6 vrid virtual-ip
Syntax
vrrp ipv6 vrid
virtual-router-id virtual-ip virtual-address
[
link-local
]
undo vrrp ipv6 vrid virtual-router-id
[
virtual-ip
virtual-address
[
link-local
]
]
View
Interface view
Default Level
2: System level
Parameters
virtual-router-id
:
VRRP group number, in the range 1 to 255.
virtual-address
: Virtual IPv6 address.
link-local
: Indicates that the virtual IPv6 address of the VRRP group is a link local address.
Description
Use the
vrrp
ipv6
vrid virtual-ip
command to create a VRRP group, and configure a virtual IPv6
address for it.
Use the
undo
vrrp ipv6 vrid virtual-ip
command to remove an existing VRRP group or the virtual IPv6
address of the VRRP group.
By default, no VRRP group is created.
Note that:
z
The first virtual IPv6 address assigned to a VRRP group must be a link local address and only one
such address is allowed in a VRRP group.
z
After you remove all virtual IPv6 addresses, the VRRP group is automatically removed. The first
address assigned to the group must be removed the last.
Examples
# Create VRRP group 1, and configure its virtual IPv6 address as fe80::10.
[Sysname] interface vlan-interface 2
[Sysname-Vlan-interface2] vrrp ipv6 vrid 1 virtual-ip fe80::10
# Configure the virtual IPv6 address of VRRP group 1 as 1::10.
[Sysname-Vlan-interface2] vrrp ipv6 vrid 1 virtual-ip 1::10