3Com S7902E Command Reference Manual - page 150
1-8
# Reset DLDP state for GigabitEthernet 2/0/1 (assuming that GigabitEthernet 2/0/1 is shut down by
DLDP).
[Sysname] interface GigabitEthernet 2/0/1
[Sysname-GigabitEthernet2/0/1] dldp reset
# Reset DLDP state for all the ports in port group 1 shut down by DLDP.
[Sysname] port-group manual 1
[Sysname-port-group-manual-1] group-member GigabitEthernet 2/0/1 to GigabitEthernet 2/0/3
[Sysname-port-group-manual-1] dldp reset
dldp unidirectional-shutdown
Syntax
dldp unidirectional-shutdown
{
auto
|
manual
}
undo
dldp unidirectional-shutdown
View
System view
Default Level
2: System level
Parameters
auto
: Sets the port shutdown mode as auto mode, where, when a unidirectional link is detected, the
port involved is shut down by DLDP.
manual
: Sets the port shutdown mode as manual mode, where, when a unidirectional link is detected,
DLDP prompts you to shut down the involved port instead of doing so automatically.
Description
Use the
dldp unidirectional-shutdown
command to set the port shutdown mode.
Use the
undo dldp unidirectional-shutdown
command to restore the default.
By default, the port shutdown mode is auto mode.
Related commands:
dldp work-mode
.
Examples
# Set the port shutdown mode as auto mode.
[Sysname] dldp unidirectional-shutdown auto
dldp work-mode
Syntax
dldp work-mode
{
enhance
|
normal
}
undo
dldp work-mode