3Com S7902E Command Reference Manual - page 1087
1-17
Parameters
None
Description
Use the
if-match mpls-label
command to specify the MPLS label match criterion.
Use the
undo if-match mpls-label
command to remove the match criterion.
The match criterion is not configured by default.
Examples
# Configure node 10 in permit mode of route policy
policy1
to match the MPLS labels of routing
updates.
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy] if-match mpls-label
if-match route-type
Syntax
if-match route-type
{
internal
|
external
-
type1
|
external-type2
|
external-type1or2
|
is-is-level-1
|
is-is-level-2
|
nssa-external-type1
|
nssa-external-type2
|
nssa-external-type1or2
} *
undo if-match route-type
[
internal
|
external
-
type1
|
external-type2
|
external-type1or2
|
is-is-level-1
|
is-is-level-2
|
nssa-external-type1
|
nssa-external-type2
|
nssa-external-type1or2
] *
View
Route policy view
Default Level
2: System level
Parameters
internal
: Internal routes (OSPF intra-area and inter-area routes).
external-type1
: OSPF Type 1 external routes.
external-type2
: OSPF Type 2 external routes.
external-type1or2
: OSPF Type 1 or 2 external routes.
is-is-level-1
: IS-IS Level-1 routes.
is-is-level-2
: IS-IS Level-2 routes.
nssa-external-type1
: OSPF NSSA Type 1 external routes.
nssa-external-type2
: OSPF NSSA Type 2 external routes.
nssa-external-type1or2
: OSPF NSSA Type 1 or 2 external routes.
Description
Use the
if-match route-type
command to configure a route type match criterion.
Use the
undo if-match route-type
command to remove the match criterion.
The match criterion is not configured by default.