3Com S7902E Command Reference Manual - page 717
1-17
rip
Syntax
rip
[
process-id
] [
vpn-instance
vpn-instance-name
]
undo rip
[
process-id
] [
vpn-instance
vpn-instance-name
]
View
System view
Default Level
2: System level
Parameters
process-id
: RIP process ID, in the range of 1 to 65535. The default is 1.
vpn-instance vpn-instance-name
: Specifies a VPN instance name, a string of 1 to 31 case-sensitive
characters.
Description
Use the
rip
command to create a RIP process and enter RIP view.
Use the
undo rip
command to disable a RIP process.
By default, no RIP process runs.
Note that:
z
If no VPN instance is specified, the RIP process will run under public network instance.
z
You must create a VPN instance before you apply a RIP process to it. For related configuration,
refer to the
ip
vpn-instance
command.
z
You must enable the RIP process before configuring the global parameters. This limitation is not for
configuration of interface parameters.
z
The configured interface parameters become invalid after you disable the RIP process.
Examples
# Create a RIP process and enter RIP process view.
[Sysname] rip
[Sysname-rip-1]
rip authentication-mode
Syntax
rip authentication-mode
{
md5
{
rfc2082
key-string
key-id
|
rfc2453
key-string
} |
simple
password
}
undo rip authentication-mode
View
Interface view