3Com S7902E Command Reference Manual - Mld Configuration Commands
1-1
1
MLD Configuration Commands
The term “router” in this document refers to a router in a generic sense or a Layer 3 switch running MLD.
MLD Configuration Commands
display mld group
Syntax
display mld group
[
ipv6-group-address
|
interface
interface-type interface-number
] [
static
|
verbose
]
View
Any view
Default Level
1: Monitor level
Parameters
ipv6-group-address
: MLD multicast group address, in the range of FFxy::/16 (excluding FFx0::/16,
FFx1::/16, FFx2::/16, and FF0y::), where x and y represent any hexadecimal number ranging from 0 to
F.
interface
interface-type interface-number
: Displays the information of MLD multicast groups on the
specified interface.
static
: Displays the information of statically joined MLD multicast groups.
verbose
: Displays detailed information of MLD multicast groups.
Description
Use the
display mld group
command to view information of MLD multicast groups.
Note that:
z
If you do not specify an IPv6 mutlicast group address, this command will display the MLD
information of all the multicast groups.
z
If you do not specify
interface-type interface-number
, this command will display the MLD multicast
group information on all the interfaces.
z
If you do not specify the
static
keyword, the information of only dynamically joined MLD groups will
be displayed.