3Com S7902E Command Reference Manual - page 161
1-8
Parameters
control-vlan vlan-id-list
: Specifies the control VLANs used for receiving flush messages. The
vlan-id-list
is expressed in the form of
vlan-id-list
= {
vlan-id
[
to
vlan-id
] }&, where the
vlan-id
argument ranges from 1 to 4094 and & indicates that you can provide up to ten VLAN IDs or
VLAN ID lists.
Description
Use the
smart-link flush enable
command to configure a VLAN for receiving flush messages, that is, a
receive control VLAN, on a port in Ethernet interface view or on all ports in system view.
Use the
undo smart-link flush enable
command to disable flush message processing.
By default, flush messages are not processed.
Note that:
z
If no VLAN is specified, VLAN 1 applies.
z
This command cannot be used on member port of an aggregation group or service loopback group.
Related commands:
flush enable
.
Examples
# Enable GigabitEthernet 2/0/1 to process the flush messages received in VLAN 1.
[Sysname] interface GigabitEthernet 2/0/1
[Sysname-GigabitEthernet2/0/1] smart-link flush enable
# Enable Layer-2 aggregate interface 1 to process the flush messages received in VLAN 1.
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] smart-link flush enable
smart-link group
Syntax
smart-link group group-id
undo smart-link group group-id
View
System view
Default Level
2: System level
Parameters
group-id
: Smart link group ID. The minimum value is 1, while the maximum value is 48.
Description
Use the
smart-link group
command to create a smart link group and enter smart link group view.
Use the
undo link-aggregation group
command to remove a smart link group.