3Com S7902E Command Reference Manual - page 663
1-3
[Sysname] sflow agent ip 10.10.10.1
sflow collector ip
Syntax
sflow collector ip
ip-address
[
port
portnum
]
undo sflow collector ip
ip-address
View
System view
Default Level
2: System level
Parameters
ip-address
: IP address of the sFlow collector.
port
portnum
: Port number of the sFlow Collector, which is in the range 1 to 65535 and defaults to 6343.
Description
Use the
sflow collector ip
command to specify the IP address and port number of an sFlow collector.
Use the
undo sflow collector ip
command to remove the specified IP address.
By default, no sFlow collector IP address is specified.
Note that:
z
The sFlow collector and sFlow agent must not have the same IP address.
z
Currently, you can specify at most two sFlow collectors, with one as the backup sFlow collector.
z
sFlow does not work if no sFlow collector IP address is specified.
z
If only one sFlow collector IP address is specified, sFlow does not work after you execute the
undo
sflow collector ip
command.
Examples
# Specify the IP address and port number of an sFlow collector.
[Sysname] sflow collector ip 10.10.10.2 port 6343
sflow enable
Syntax
sflow
enable
{
inbound
|
outbound
}
undo sflow
enable
{
inbound
|
outbound
}
View
Interface view
Default Level
2: System level