- DL manuals
- 3Com
- Switch
- S7902E
- Command Reference Manual
3Com S7902E Command Reference Manual - Urpf Configuration Commands
of
2327
Go
1-1
1
URPF Configuration Commands
URPF Configuration Commands
ip urpf strict
Syntax
ip urpf
strict
undo ip urpf
View
Interface view
Default Level
2: System level
Parameters
None
Description
Use the
ip urpf strict
command to enable URPF check.
Use the
undo
ip urpf
command to disable URPF check.
By default, URPF check is disabled.
After URPF is enabled on an S7900E switch, the routing table capacity on a board may decrease to a
half. For details, refer to the section of configuring URPF in the operation manual.
Examples
# Enable URPF check.
[Sysname] ip urpf strict