3Com S7902E Command Reference Manual - page 1111
1-7
Parameters
all-instance
: Specifies all instances.
vpn-instance vpn-instance-name
: Specifies a VPN instance. A VPN instance name is a case sensitive
string of up to 31 characters and must not contain any space.
config
: Displays the configuration information of static routes.
source-address
: Multicast source address.
mask
: Mask of the multicast source address.
mask-length
: Mask length of the multicast source address, in the range of 0 to 32.
Description
Use the
display multicast routing-table static
command to view the information of multicast static
routes.
Note that if neither
all-instance
nor
vpn-instance
is specified, this command displays the information
on the public instance.
Examples
# View all the multicast static routes in the public instance.
Multicast Routing Table of VPN-Instance: public net
Routes : 1
Mroute 10.10.0.0/16
Interface = Vlan-interface1 RPF Neighbor = 2.2.2.2
Matched routing protocol =
Preference = 1, Order = 1
Running Configuration = ip rpf-route-static 10.10.0.0 16 2.2.2.2 order 1
# View the configuration information of multicast static routes in the public instance.
Multicast Routing Table of VPN-Instance: public net
Routes : 1
Mroute 10.10.0.0/16, RPF neighbor = 2.2.2.2
Matched routing protocol =
Preference = 1, Order = 1
Table 1-5 display multicast routing-table static
command output description
Field
Description
Multicast Routing Table of VPN-Instance: public
net
Multicast routing table for the public network
Mroute
Multicast route source address and its mask
length
Interface
Outgoing interface to the multicast source