3Com S7902E Command Reference Manual - page 848
1-49
level-2
: Configures the router to work on Level-2, which means it calculates routes and maintains the
LSDB for L2 only.
Description
Use the
is-level
command to specify the IS level.
Use the
undo is-level
command to restore the default.
The default IS level is
level-1-2
.
You can configure all the routers as either Level-1 or Level-2 if there is only one area, because there is
no need for all routers to maintain two identical databases at the same time. If the only area is an IP
network, you are recommended to configure all the routers as Level-2 for scalability.
Related commands:
isis circuit-level
.
Examples
# Configure the router to work in Level-1.
[Sysname] isis
[Sysname-isis-1] is-level level-1
is-name
Syntax
is-name sys-name
undo is-name
View
IS-IS view
Default Level
2: System level
Parameters
symbolic-name
: Specifies a host name for the local IS, a string of 1 to 64 characters.
Description
Use the
is-name
command to specify a host name for the IS to enable dynamic system ID to hostname
mapping.
Use the
undo is-name
command to disable dynamic system ID to hostname mapping.
Dynamic system ID to hostname mapping is not enabled by default.
Examples
# Configure a host name for the local IS.
[Sysname] isis
[Sysname-isis-1] is-name RUTA