3Com S7902E Command Reference Manual - page 766
1-34
Parameters
acl-number
: Number of an ACL used to filter incoming routes, in the range 2000 to 3999.
ip-prefix-name
: Name of an IP address prefix list used to filter incoming routes based on destination IP
address, a string of up to 19 characters. For details about IP prefix lists, refer to
Route Policy
Configuration
in the
IP Routing Volume
.
gateway ip-prefix-name
: Name of an IP address prefix list used to filter routes based on the next hop of
the routing information, a string of up to 19 characters.
Description
Use the
filter-policy import
command to configure the filtering of routes calculated from received
LSAs.
Use the
undo filter-policy import
command to disable the filtering.
By default, the filtering is not configured.
Examples
# Filter incoming routes using ACL2000.
[Sysname] acl number 2000
[Sysname-acl-basic-2000] rule permit source 192.168.10.0 0.0.0.255
[Sysname-acl-basic-2000] quit
[Sysname] ospf 100
[Sysname-ospf-100] filter-policy 2000 import
graceful-restart (OSPF view)
Syntax
graceful-restart
[
nonstandard
|
ietf
]
undo graceful-restart
View
OSPF view
Default Level
2: System level
Parameters
nonstandard
: Enables the non-IETF GR capability.
ietf
: Enables the IETF GR capability.
Description
Use the
graceful-restart
command to enable OSPF Graceful Restart capability.
Use the
undo graceful-restart
command to disable OSPF Graceful Restart capability.
By default, OSPF Graceful Restart capability is disabled.
Note the following: