3Com S7902E Command Reference Manual - page 148
1-6
Parameters
None
Description
Use the
dldp enable
command to enable DLDP.
Use the
undo dldp enable
command to disable DLDP.
When executed in system view, these two commands enables/disables DLDP globally; when executed
in Ethernet port view, these two commands enables/disables DLDP on the current port; when executed
in port group view, these two commands enables/disables DLDP on all the ports in the port group.
By default, DLDP is disabled globally or on a port.
z
These two commands are applicable to Layer 2 Ethernet ports, including optical ports and
electrical ports.
z
DLDP can take effect only when it is enabled both globally and on a port.
Examples
# Enable DLDP globally.
[Sysname] dldp enable
# Enable DLDP on GigabitEthernet 2/0/1.
[Sysname] interface GigabitEthernet 2/0/1
[Sysname-GigabitEthernet2/0/1] dldp enable
# Enable DLDP for all the ports in port group 1.
[Sysname] port-group manual 1
[Sysname-port-group-manual-1] group-member GigabitEthernet 2/0/1 to GigabitEthernet 2/0/3
[Sysname-port-group-manual-1] dldp enable
dldp interval
Syntax
dldp interval time
undo dldp interval
View
System view
Default Level
2: System level