3Com S7902E Command Reference Manual - page 1495
1-25
Default Level
2: System level
Parameters
None
Description
Use the
mld-snooping report-aggregation
command to enable MLD report suppression.
Use the
undo mld-snooping report-aggregation
command to disable MLD report suppression.
By default, MLD report suppression is enabled.
This command works on both MLD Snooping–enabled VLANs and VLANs with MLD enabled on their
VLAN interfaces.
Examples
# Disable MLD report suppression.
[Sysname] mld-snooping
[Sysname-mld-snooping] undo report-aggregation
reset mld-snooping group
Syntax
reset mld-snooping group
{
ipv6-group-address
|
all
} [
vlan
vlan-id
]
View
User view
Default Level
2: System level
Parameters
ipv6-group-address
: Clears the information about the specified multicast group. The effective range of
ipv6-group-address
is FFxy::/16 (excluding FFx0::/16, FFx1::/16, FFx2::/16 and FF0y::), where x and y
represent any hexadecimal number between 0 and F, inclusive.
all
: Clears all MLD Snooping multicast group information.
vlan vlan-id
: Clears the MLD Snooping multicast group information in the specified VLAN. The effective
range of
vlan-id
is 1 to 4094.
Description
Use the
reset mld-snooping group
command to clear MLD Snooping multicast group information.
Note that:
z
This command works only on MLD Snooping–enabled VLANs, but not on VLANs with MLD
enabled on their VLAN interfaces.
z
This command cannot clear MLD Snooping multicast group information of static joining.