3Com S7902E Command Reference Manual - page 1160
1-3
Parameters
interface-type interface-number
: Specifies an interface by its type and number. This configuration can
take effect only if PIM-SM is enabled on the interface.
hash-length
: Hash mask length, in the range of 0 to 32. If you do not include this argument in your
command, the corresponding global setting will be used.
priority
: Priority of the C-BSR, in the range of 0 to 255. If you do not include this argument in your
command, the corresponding global setting will be used. A larger value of this argument means a higher
priority.
Description
Use the
c-bsr
command to configure the specified interface as a C-BSR.
Use the
undo c-bsr
command to remove the related C-BSR configuration.
No C-BSR is configured by default.
Note that PIM-SM must be enabled on the interface to be configured as a C-BSR.
Related commands:
pim sm
,
c-bsr hash-length
,
c-bsr priority
,
c-rp
.
Examples
# Configure VLAN-interface 100 to be a C-BSR.
[Sysname] pim
[Sysname-pim] c-bsr vlan-interface 100
c-bsr admin-scope
Syntax
c-bsr admin-scope
undo c-bsr admin-scope
View
Public instance PIM view, VPN instance PIM view
Default Level
2: System level
Parameters
None
Description
Use the
c-bsr admin-scope
command to enable administrative scoping.
Use the
undo c-bsr admin-scope
command to disable administrative scoping.
By default, BSR administrative scoping is disabled, namely there is only one BSR in a PIM-SM domain.
Related commands:
c-bsr
,
c-bsr group
,
c-bsr global
.