3Com S7902E Command Reference Manual - page 982
1-23
Field
Description
Transmit Delay
Transmit delay of sending LSAs
State Interface
state
Timer intervals configured, Hello: 10, Dead: 40,
Wait: 40, Retransmit: 5
Timer intervals in seconds, Hello: 10, Dead: 40,
Wait: 40, Retransmit: 5
Hello due in 00:00:02
Send hello packets in 2 seconds.
Adjacency state
Adjacency state
filter-policy export (OSPFv3 view)
Syntax
filter-policy
{
acl6-number
|
ipv6-prefix
ipv6-prefix-name
}
export
[
isisv6 process-id
|
ospfv3
process-id
|
ripng process-id
|
bgp4+
|
direct
|
static
]
undo filter-policy export
[
isisv6 process-id
|
ospfv3 process-id
|
ripng process-id
|
bgp4+
|
direct
|
static
]
View
OSPFv3 view
Default Level
2: System level
Parameters
acl6-number
: Specifies the ACL6 number, ranging from 2000 to 3999.
ipv6-prefix
ipv6-prefix-name
: Specifies the name of an IPv6 prefix list, a string of up to 19 characters.
isisv6 process-id
: Specifies to filter the routes of an IPv6-IS-IS process, which is in the range of 1 to
65535.
ospfv3 process-id
: Specifies to filter the routes of an OSPFv3 process, which is in the range of 1 to
65535.
ripng process-id
: Specifies to filter the routes of a RIPng process, which in the range of 1 to 65535.
bgp4+
: Specifies to filter BGP4+ routes.
direct
: Specifies to filter direct routes.
static
: Specifies to filter static routes.
Description
Use the
filter-policy export
command to filter redistributed routes.
Use the
undo filter-policy export
command to remove the configuration.
If no protocol is specified, all redistributed routes will be filtered.
By default, IPv6 OSPFv3 does not filter redistributed routes.