3Com S7902E Command Reference Manual - page 1488
1-18
mld-snooping querier
Syntax
mld-snooping querier
undo mld-snooping querier
View
VLAN view
Default Level
2: System level
Parameters
None
Description
Use the
mld-snooping querier
command to enable the MLD Snooping querier function.
Use the
undo mld-snooping querier
command to disable the MLD Snooping querier function.
By default, the MLD Snooping querier function is disabled.
Note that:
z
This command takes effect only if MLD Snooping is enabled in the VLAN.
z
This command does not take effect in a sub-VLAN of an IPv6 multicast VLAN.
Related commands:
subvlan
command in
IPv6 Multicast VLAN Commands
in the
IP Multicast Volume
.
Examples
# Enable the MLD Snooping querier function in VLAN 2.
[Sysname] vlan 2
[Sysname-vlan2] mld-snooping querier
mld-snooping query-interval
Syntax
mld-snooping query-interval
interval
undo mld-snooping query-interval
View
VLAN view
Default Level
2: System level
Parameters
interval
: MLD query interval in seconds, namely the length of time the device waits between sending
MLD general queries. The effective range is 2 to 300.