3Com S7902E Command Reference Manual - page 1365
1-26
Default level
2: System level
Parameters
ipv6-group-address
: Specifies an IPv6 multicast group by its IPv6 address, in the form of FFxy::/16,
where x and y represent any hexadecimal number ranging from 0 to F.
prefix-length
: Prefix length of the IPv6 multicast group address, in the range of 8 to 128.
ipv6-source-address
: Specifies a multicast source by its IPv6 address.
all
: Removes all MLD SSM mappings.
Description
Use the
ssm-mapping
command to configure an MLD SSM mapping.
Use the
undo ssm-mapping
command to remove one or all MLD SSM mappings.
By default, no MLD SSM mappings are configured.
Related commands:
mld ssm-mapping enable
,
display mld ssm-mapping
.
Examples
# Configure an MLD SSM mapping for multicast group FF1E::101/64 and multicast source 1::1.
[Sysname] mld
[Sysname-mld] ssm-mapping ff1e::101 64 1::1
startup-query-count (MLD view)
Syntax
startup-query-count
value
undo startup-query-count
View
MLD view
Default Level
2: System level
Parameters
value
: Startup query count, namely, the number of queries the MLD querier sends on startup, with an
effective range of 2 to 5.
Description
Use the
startup-query-count
command to configure the startup query count globally.
Use the
undo startup-query-count
command to restore the system default.
By default, the startup query count is set to the MLD querier robustness variable.