3Com S7902E Command Reference Manual - page 2275
1-30
Description
Use the
nqa server enable
command to enable the NQA server.
Use the
undo
nqa server enable
command to disable the NQA server.
By default, the NQA server is disabled.
Related commands:
nqa server tcp-connect, nqa server udp-echo
.
Examples
# Enable the NQA server.
[Sysname] nqa server enable
nqa server tcp-connect
Syntax
nqa server tcp-connect
ip-address port-number
undo nqa server tcp-connect
ip-address port-number
View
System view
Default Level
2: System level
Parameters
ip-address
: IP address specified for the TCP listening service on the NQA server.
port-number
: Port number specified for the TCP listening service on the NQA server, in the range 1 to
50000.-
Description
Use the
nqa-server tcp-connect
command to create a TCP listening service on the NQA server.
Use the
undo nqa-server tcp-connect
command to remove the TCP listening service created.
Note that:
z
You need to configure the command on the NQA server for TCP tests only.
z
The IP address and port number must be consistent with those on the NQA client and must be
different from those for an existing listening service.
z
The IP address must be that of an interface on the NQA server. Otherwise, the configuration will be
invalid.
Related commands:
nqa server enable
.
Examples
# Create a TCP listening service by using the IP address 169.254.10.2 and port 9000.
[Sysname] nqa server tcp-connect 169.254.10.2 9000