3Com S7902E Command Reference Manual - page 1407
1-36
By default, IPv6 PIM-SM is disabled.
Note that this command can take effect only after IPv6 multicast routing is enabled on the device.
Related commands:
pim ipv6 dm
;
multicast ipv6 routing-table
in the
IPv6 Multicast Routing and
Forwarding Commands
in the
IP Multicast Volume
.
Examples
# Enable IPv6 multicast routing, and enable IPv6 PIM-SM on VLAN-interface 100.
[Sysname] multicast ipv6 routing-enable
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] pim ipv6 sm
pim ipv6 state-refresh-capable
Syntax
pim ipv6 state-refresh-capable
undo pim ipv6 state-refresh-capable
View
Interface view
Default Level
2: System level
Parameters
None
Description
Use the
pim ipv6 state-refresh-capable
command to enable the state fresh feature on the interface.
Use the
undo pim ipv6 state-refresh-capable
command to disable the state fresh feature.
By default, the state refresh feature is enabled.
Related commands:
state-refresh-interval
,
state-refresh-rate-limit
,
state-refresh-hoplimit
.
Examples
# Disable state refresh on VLAN-interface 100.
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] undo pim ipv6 state-refresh-capable
pim ipv6 timer graft-retry
Syntax
pim ipv6 timer graft-retry
interval
undo pim ipv6 timer graft-retry