3Com S7902E Command Reference Manual - page 2254
1-9
Default Level
2: System level
Parameters
interval
: Interval between two consecutive tests, in milliseconds, in the range 0 to 604800000. If the
interval is 0, it indicates that only one test is performed.
Description
Use the
frequency
command to configure the interval between two consecutive tests for a test group.
Use the
undo frequency
command to restore the default.
By default, the interval between two consecutive tests for a test group is 0 milliseconds, that is, only one
test is performed.
After you use the
nqa
schedule
command to start an NQA test, one test is started at
interval
.
If the last test is not completed when the interval specified by the
frequency
command is reached, a
new test is not started.
Examples
# Configure the interval between two consecutive tests as 1000 milliseconds.
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] frequency 1000
history-records
Syntax
history-records number
undo history-records
View
Any NQA test type view
Default Level
2: System level
Parameters
number
: Maximum number of history records that can be saved in a test group, in the range 0 to 50.