3Com S7902E Command Reference Manual - page 367
2-29
Default Level
2: System level
Parameters
uni-number
: UNI number, in the range 1 to the number of UNI ports of the current ONU. The number of
UNIs can be up to 80.
full
: Specifies the port to be in full duplex mode.
half
: Specifies the port to be in half duplex mode.
auto
: Specifies the duplex mode of the port to be auto-negotiation.
Description
Use the
uni
duplex
command to set the duplex mode for UNIs.
Use the
undo
uni
duplex
command to restore the duplex mode on the current port to the default value.
By default, the duplex mode on UNIs is full.
This command takes effect on H3C ONUs only.
Examples
# Configure UNI 1 to operate in the auto-negotiation mode.
[Sysname] interface onu 3/0/1:1
[Sysname-Onu3/0/1:1] uni 1 duplex auto
uni flow-control
Syntax
uni
uni-number flow-control
undo uni
uni-number flow-control
View
ONU port view
Default Level
2: System level
Parameters
uni-number
: UNI number, in the range 1 to the number of UNI ports of the current ONU. The number of
UNIs can be up to 80.