3Com S7902E Command Reference Manual - page 1060
1-45
peer timer (IPv6 address family view)
Syntax
peer
{
ipv6-group-name | ipv6-address
}
timer
keepalive keepalive hold holdtime
undo peer
{
ipv6-group-name | ipv6-address
}
timer
View
IPv6 address family view
Default Level
2: System level
Parameters
ipv6-group-name
: Name of a peer group, a string of 1 to 47 characters.
ipv6-address
: IPv6 address of a peer.
keepalive
: Specifies the keepalive interval in seconds, ranging from 1 to 21845.
holdtime
: Specifies the holdtime in seconds, ranging from 3 to 65535.
Description
Use the
peer timer
command to configure keepalive interval and holdtime interval for a peer or peer
group.
Use the
undo peer timer
command to restore the default.
keepalive
interval defaults to 60 seconds, and
holdtime
interval defaults to 180 seconds
Note that:
z
The timer configured with this command is preferred to the timer configured with the
timer
command.
z
The holdtime interval must be at least three times the keepalive interval.
Related commands:
timer
.
Examples
# Configure the keepalive interval and holdtime interval for the peer group test as 60 seconds and 180
seconds.
[Sysname] bgp 100 [Sysname-bgp] ipv6-family [Sysname-bgp-af-ipv6] group test external [Sysname-bgp-af-ipv6] peer test timer keepalive 60 hold 180 preference (IPv6 address family view) Syntax preference { external-preference internal-preference local-preference | route-policy route-policy-name } undo preference