3Com S7902E Command Reference Manual - page 1391
1-20
Downstream interface(s) information:
Total number of downstreams: 1
1: Vlan-interface2
Protocol: pim-dm, UpTime: 00:04:24, Expires: 00:02:47
Table 1-8
display pim ipv6 routing-table command output description
Field
Description
Total 0 (*, G) entry; 1 (S, G) entry
Number of (S, G) and (*, G) entries in the IPv6 PIM routing
table
(2001::2, FFE3::101)
An (S, G) entry in the IPv6 PIM routing table
Protocol
IPv6 PIM mode, IPv6 PIM-SM or IPv6 PIM-DM
Flag
Flag of the (S, G) or (*, G) entry in the IPv6 PIM routing
table
Uptime
Length of time since the (S, G) or (*, G) entry was installed
Upstream interface
Upstream (incoming) interface of the (S, G) or (*, G) entry
Upstream neighbor
Upstream neighbor of the (S, G) or (*, G) entry
RPF prime neighbor
RPF neighbor of the (S, G) or (*, G) entry
z
For a (*, G) entry, if this router is the RP, the RPF
neighbor of this (*, G) entry is NULL.
z
For a (S, G) entry, if this router directly connects to the
IPv6 multicast source, the RPF neighbor of this (S, G)
entry is NULL.
Downstream interface(s) information
Information of the downstream interface(s), including:
z
Number of downstream interfaces
z
Downstream interface name
z
Protocol type configured on the downstream interface
z
Uptime of the downstream interface(s)
z
Expiry time of the downstream interface(s)
display pim ipv6 rp-info
Syntax
display pim ipv6 rp-info
[
ipv6-group-address
]
View
Any view
Default Level
1: Monitor level
Parameters
ipv6-group-address
: Specifies an IPv6 multicast group by its address, in the range of FFxy::/16
(excluding FFx0::/16, FFx1::/16, FFx2::/16 and FF0y::), where x and y represent any hexadecimal
number between 0 and F, inclusive. If you do not provide a group address, this command will display the
RP information corresponding to all IPv6 multicast groups.