3Com S7902E Command Reference Manual - page 1088
1-18
Examples
# Configure node 10 in permit mode of route policy
policy1
to match OSPF internal routes.
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy] if-match route-type internal
if-match tag
Syntax
if-match tag
value
undo if-match tag
View
Route policy view
Default Level
2: System level
Parameters
value
: Specifies a tag from 0 to 4294967295.
Description
Use the
if-match tag
command to match routing information having the specified tag.
Use the
undo if-match tag
command to remove the match criterion.
The match criterion is not configured by default.
Related commands:
if-match interface
,
if-match acl
,
if-match ip-prefix
,
if-match ip next-hop
,
if-match cost
,
route-policy
,
apply ip-address next-hop
,
apply cost
,
apply local-preference
,
apply
origin
,
apply tag
.
Examples
# Configure node 10 in permit mode of route policy
policy1
to permit RIP, OSPF and IS-IS routing
information with a tag of 8.
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy] if-match tag 8
ip as-path
Syntax
ip as-path
as-path-number
{
deny
|
permit
}
regular-expression
undo ip as-path
as-path-number
View
System view