3Com S7902E Command Reference Manual - page 2172
1-7
Note the following:
z
Output of the debugging information may degrade system efficiency, so you are recommended to
enable the debugging of a specific module for diagnosing network failure, and not to enable the
debugging of multiple modules at the same time.
z
Default Level
describes the default level of the
debugging all
command. Different
debugging
commands may have different default levels.
z
You must configure the
debugging
,
terminal debugging
and
terminal monitor
commands first
to display detailed debugging information on the terminal. For the detailed description on the
terminal debugging
and
terminal monitor
commands, refer to
Information Center Commands
in
the
System Volume
.
Related commands:
display debugging
.
Examples
# Enable IP packet debugging.
display debugging
Syntax
display
debugging
[
interface
interface-type interface-number
]
[
module-name
]
View
Any view
Default Level
1: Monitor level
Parameters
interface interface-type interface-number
: Displays the debugging settings of the specified interface,
where
interface-type interface-number
represents the interface type and number.
module-name
: Module name.
Description
Use the
display debugging
command to display enabled debugging functions.
Related commands:
debugging
.
Examples
# Display all enabled debugging functions.
IP packet debugging is on