3Com S7902E Command Reference Manual - page 1046
1-31
Parameters
ipv6-group-name
: Name of a peer group, a string of 1 to 47 characters.
ipv6-address
: IPv6 address of a peer.
interface-type interface-number
: Specifies the type and name of the interface.
Description
Use the
peer connect-interface
command to specify the source interface for establishing TCP
connections to an IPv6 BGP peer or peer group.
Use the
undo peer connect-interface
command to restore the default.
By default, BGP uses the outbound interface of the best route to the IPv6 BGP peer/peer group as the
source interface for establishing a TCP connection.
Note that:
To establish multiple BGP connections to a BGP router, you need to specify on the local router the
respective source interfaces for establishing TCP connections to the peers on the peering BGP router;
otherwise, the local BGP router may fail to establish TCP connections to the peers when using the
outbound interfaces of the best routes as the source interfaces.
Examples
# Specify loopback 0 as the source interface for routing updates to peer 1:2::3:4.
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] peer 1:2::3:4 connect-interface loopback 0
peer default-route-advertise
Syntax
peer
{
group-name
|
ipv4-address
|
ipv6-address
}
default-route-advertise
[
route-policy
route-policy-name
]
undo peer
{
group-name
|
ipv4-address
|
ipv6-address
}
default-route-advertise
View
IPv6 address family view
Default Level
2: System level
Parameters
group-name
: Name of an IPv4 or IPv6 peer group, a string of 1 to 47 characters.
ipv4-address
: IPv4 address of a peer.
ipv6-address
: IPv6 address of a peer.
route-policy-name
: Route-policy name, a string of 1 to 19 characters.