3Com S7902E Command Reference Manual - page 255
1-3
Use the
undo nest
command to remove the action.
Related commands:
qos policy
,
traffic behavior
.
Examples
# Configure the action of creating outer VLAN tag 100 for the traffic behavior
database
.
[Sysname] traffic behavior database
[Sysname-behavior-database] nest top-most vlan-id 100
qinq enable
Syntax
qinq enable
undo qinq enable
View
Ethernet port view, Layer-2 aggregate interface view, port group view
Default Level
2: System level
Parameters
None
Description
Use the
qinq enable
command to enable basic QinQ for the current Ethernet port.
Use the
undo qinq enable
command to disable basic QinQ for the current Ethernet port.
By default, basic QinQ is disabled for Ethernet port.
After basic QinQ is enabled on the port, frames on this port will be tagged with a new VLAN tag, the
VLAN ID in which is the default VLAN ID of the port.
Configured in Ethernet port view, the setting is effective on the current port only; configured in port
group view, the setting is effective on all ports in the port group.
Examples
# Enable basic QinQ on port GigabitEthernet 2/0/1.
[Sysname] interface GigabitEthernet 2/0/1
[Sysname-GigabitEthernet2/0/1] qinq enable
# Enable basic QinQ on Layer-2 aggregate interface 1.
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] qinq enable