3Com S7902E Command Reference Manual - page 218
1-26
Configuring GigabitEthernet2/0/1... Done.
[Sysname-Bridge-Aggregation1] port hybrid protocol-vlan vlan 2 0
protocol-vlan
Syntax
protocol-vlan
[
protocol-index
] {
at
|
ipv4 | ipv6
|
ipx
{
ethernetii |
llc
|
raw |
snap
} |
mode
{
ethernetii
etype etype-id
|
llc
{
dsap dsap-id
[
ssap ssap-id
]
|
ssap ssap-id
} |
snap
etype etype-id
} }
undo protocol-vlan
{
protocol-index
[
to
protocol-end
] |
all
}
View
VLAN view
Default Level
2: System level
Parameters
at
: Specifies the AppleTalk based VLAN.
ipv4
: Specifies the IPv4 based VLAN.
ipv6
: Specifies the IPv6 based VLAN.
ipx
: Specifies the IPX based VLAN. The keywords
ethernetii
,
llc
,
raw
, and
snap
are encapsulation
formats for IPX.
mode
: Configures a user-defined protocol template for the VLAN, which could also have four
encapsulation formats, namely,
ethernetii
,
llc
,
raw
, and
snap
.
ethernetii etype
etype-id
: Specifies to match Ethernet II encapsulation format and the corresponding
protocol type values. The
etype-id
argument is the protocol type ID of inbound packets, in the range
0x0600 to 0xffff (excluding 0x0800, 0x809b, 0x8137, and 0x86dd).
llc
: Specifies to match the
llc
encapsulation format.
dsap dsap-id
: Specifies the destination service access point, in the range of 00 to 0xff.
ssap
ssap-id
: Specifies the source service access point, in the range of 00 to 0xff.
snap etype
etype-id
: Specifies to match SNAP encapsulation format and the corresponding protocol
type values. The
etype-id
argument is the Ethernet type of inbound packets, in the range 0x0600 to
0xffff (excluding
ipx snap
under the
snap
encapsulation format).
protocol-index
: Protocol index, which specifies the protocol template to be bound with the current VLAN,
in the range 0 to 15. System will automatically assign an index if this parameter is not specified.
to
protocol-end
: Specifies the end protocol index, in the range 0 to 15. The
protocol-end
argument must
be greater than or equal to the
protocol-index
argument
.
all
: Specifies to remove all the protocols bound with the current VLAN.