3Com S7902E Command Reference Manual - page 637
1-29
Parameters
value
: Number of hops, in the range of 0 to 255. When it is set to 0, the Hop Limit field in RA messages
sent by the device is 0. That is, the number of hops is determined by the requesting device itself.
Description
Use the
ipv6 nd hop-limit
command to configure the hop limit advertised by the device.
Use the
undo ipv6 nd hop-limit
command to restore the default hop limit.
By default, the hop limit advertised by the device is 64.
Examples
# Set the hop limit advertised by the device to 100.
[Sysname] ipv6 nd hop-limit 100
ipv6 nd ns retrans-timer
Syntax
ipv6 nd ns retrans-timer
value
undo ipv6 nd ns retrans-timer
View
Interface view
Default Level
2: System level
Parameters
value
: Interval for retransmitting an NS message in milliseconds, in the range of 1,000 to
4,294,967,295.
Description
Use the
ipv6 nd ns retrans-timer
command to set the interval for retransmitting an NS message. The
local interface retransmits an NS message at intervals of this value. Furthermore, the Retrans Timer
field in RA messages sent by the local interface is equal to this value.
Use the
undo ipv6 nd ns retrans-timer
command to restore the default.
By default, the local interface retransmits an NS message at intervals of 1,000 milliseconds and the
Retrans Timer field in RA messages sent by the local interface is 0.
Examples
# Specify VLAN-interface 100 to retransmit NS messages at intervals of 10,000 milliseconds.
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ipv6 nd ns retrans-timer 10000