3Com S7902E Command Reference Manual - page 2198
1-25
Examples
# Configure the system to output information to the trap buffer through the default channel, and set the
trap buffer size to 30.
[Sysname] info-center trapbuffer size 30
logfile save
Syntax
logfile save
View
Any view
Default Level
2: System level
Parameters
None
Description
Use the
logfile save
command to save all the contents in the logfile buffer into the log file.
By default, the system automatically saves the log file based on a frequency configured by the
info-center logfile frequency
command into a directory configured by the
info-center logfile
switch-directory
command.
Note that all contents in the logfile buffer will be cleared after they are successfully saved into the log file
automatically or manually.
By default, the log file is automatically saved to the logfile directory under root directory of the CF card
(cf:/logfile). If there is no CF card, you can use the
info-center logfile switch-directory
command to
configure the directory where a log file is saved, otherwise, the system will prompt you that the save
operation failed.
Examples
# Save the contents in the logfile buffer into the log file.
reset logbuffer
Syntax
reset logbuffer