3Com S7902E Command Reference Manual - page 1198
1-41
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] pim sm
pim state-refresh-capable
Syntax
pim state-refresh-capable
undo pim state-refresh-capable
View
Interface view
Default Level
2: System level
Parameters
None
Description
Use the
pim state-refresh-capable
command to enable the state fresh feature on the interface.
Use the
undo pim state-refresh-capable
command to disable the state fresh feature.
By default, the state refresh feature is enabled.
Related commands:
state-refresh-interval
,
state-refresh-rate-limit
,
state-refresh-ttl
.
Examples
# Disable state refresh on VLAN-interface 100.
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] undo pim state-refresh-capable
pim timer graft-retry
Syntax
pim timer graft-retry interval
undo pim timer graft-retry
View
Interface view
Default Level
2: System level
Parameters
interval
: Graft retry period in seconds, with an effective range of 1 to 65,535.