3Com S7902E Command Reference Manual - page 2267
1-22
View
DLSw, FTP, HTTP, ICMP-echo, SNMP, TCP, UDP-echo, UDP-jitter test type view
Default Level
2: System level
Parameters
None
Description
Use the
route-option bypass-route
command to enable the routing table bypass function to test the
direct connectivity to the direct destination.
Use the
undo
route-option bypass-route
command to disable the routing table bypass function.
By default, the routing table bypass function is disabled.
Note that after this function is enabled, the routing table is not searched, and the packet is directly sent
to the destination in a directly connected network.
Examples
# Enable the routing table bypass function.
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] route-option bypass-route
source interface
Syntax
source interface
interface-type interface-number
undo source interface
View
ICMP-echo test type view
Default Level
2: System level
Parameters
interface-type interface-number
: Interface type and the interface number of the source interface of a
probe packet.
Description
Use the
source interface
command to specify the IP address of an interface as the source IP address
of ICMP-echo probe requests.
Use the
undo
source interface
command to remove the IP address of an interface as the source IP
address of ICMP-echo probe requests.