3Com S7902E Command Reference Manual - page 923
1-59
View
BGP view
Default Level
2: System level
Parameters
group-name
: Name of a peer group, a string of 1 to 47 characters.
ip-address
: IP address of a peer.
Description
Use the
peer reflect-client
command to configure the router as a route reflector and specify a
peer/peer group as a client.
Use the
undo peer reflect-client
command to remove the configuration.
By default, neither the route reflector nor the client is configured.
Related commands:
reflect between-clients
and
reflect cluster-id
.
Examples
# In BGP view, configure the local device as a route reflector and specify the IBGP peer group
test
as a
client.
[Sysname] bgp 100
[Sysname-bgp] peer test reflect-client
peer route-limit (BGP/BGP-VPN instance view)
Syntax
peer
{
group-name
|
ip-address
}
route-limit prefix-number
[ {
alert-only
|
reconnect
reconnect-time
}
|
percentage-value
] *
undo peer
{
group-name
|
ip-address
}
route-limit
View
BGP view/BGP-VPN instance view
Default Level
2: System level
Parameters
group-name
: Name of a peer group, a string of 1 to 47 characters.
ip-address
: IP address of a peer.
prefix-number
: Number of prefixes that can be received from the peer or peer group, in the range 1 to
128000. If the number of prefixes received from the peer/peer group reaches the
prefix-number
, the
router will tear down the connection to the peer/peer group.
alert-only
: If the number of prefixes received from the peer/peer group reaches the
prefix-number
, the
router will not tear down the connection to the peer/peer group but display an alarm message.