3Com S7902E Command Reference Manual - page 1099
1-29
Field
Description
ge
greater-equal, the lower prefix length
Le
less-equal, the upper prefix length
if-match ipv6
Syntax
if-match ipv6
{
address
|
next-hop
|
route-source
} {
acl acl6-number |
prefix-list
ipv6-prefix-name
}
undo if-match ipv6
{
address
|
next-hop
|
route-source
} [
acl |
prefix-list
]
View
Route policy view
Default Level
2: System level
Parameters
address
: Matches the destination address of IPv6 routing information.
next-hop
: Matches the next hop of IPv6 routing information.
route-source
: Matches the source address of IPv6 routing information.
acl acl6-number
: Specifies the number of an IPv6 ACL for filtering, in the range 2000 to 3999 for
address
, and 2000 to 2999 for
next-hop
and
route-source
.
prefix-list
ipv6-prefix-name
: Specifies the name of a IPv6 prefix list for filtering, a string of 1 to 19
characters.
Description
Use the
if-match ipv6
command to configure a destination, next hop or source address based match
criterion for IPv6 routes.
Use the
undo if-match ipv6
command to remove the match criterion.
The match criterion is not configured by default.
Examples
# Configure node 10 of route policy
policy1
to permit routing information whose next hop address
matches IPv6 prefix list p1.
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy] if-match ipv6 next-hop prefix-list p1
ip ipv6-prefix
Syntax
ip ipv6-prefix ipv6-prefix-name
[
index index-number
] {
deny
|
permit
}
ipv6-address prefix-length
[
greater-equal min-prefix-length
] [
less-equal max-prefix-length
]