3Com S7902E Command Reference Manual - page 771
1-39
[Sysname] ospf 100
[Sysname-ospf-100] import-route rip 40 type 2 tag 33 cost 50
log-peer-change
Syntax
log-peer-change
undo log-peer-change
View
OSPF view
Default Level
2: System level
Parameters
None
Description
Use the
log-peer-change
command to enable the logging of OSPF neighbor state changes.
Use the
undo log-peer-change
command to disable the logging.
The logging is enabled by default.
With this feature enabled, information about neighbor state changes is displayed on the terminal until
the feature is disabled.
Examples
# Disable the logging of neighbor state changes for OSPF process 100.
[Sysname] ospf 100
[Sysname-ospf-100] undo log-peer-change
lsa-arrival-interval
Syntax
lsa-arrival-interval interval
undo lsa-arrival-interval
View
OSPF view
Default Level
2: System level
Parameters
interval
: Specifies the minimum LSA repeat arrival interval in milliseconds, in the range 0 to 60000.