3Com S7902E Command Reference Manual - page 304
1-19
View
Any view
Default level
1: Monitor level
Parameters
interface interface-type interface-number
: Specifies a port by its type and number.
Description
Use the
display cfd mp
command to display the MP information.
If no port is specified, this command will display the MP information of all ports.
The information displayed is ordered by port name primarily, and within a single port, ordered by VLAN
ID (from small to big), and within a single VLAN, in the order of outward-facing MEPs (from low to high
level), MIPs, and inward-facing MEPs (from high to low level).
Examples
# Display the MP information.
Interface GigabitEthernet2/0/2 VLAN 100
MEP ID: 100 Level: 0 Service instance: 100 Direction: Outbound
Maintenance domain: mdtest0
Maintenance association: mainmd0
MEP ID: 105 Level: 5 Service instance: 105 Direction: Outbound
Maintenance domain: mdtest5
Maintenance association: mainmd5
MIP Level: 6 Service instance: 106
Maintenance domain: mdtest6
Maintenance association: mainmd6
MEP ID: 104 Level: 4 Service instance: 104 Direction: Inbound
Maintenance domain: mdtest4
Maintenance association: mainmd4
MEP ID: 102 Level: 2 Service instance: 102 Direction: Inbound
Maintenance domain: mdtest2
Maintenance association: mainmd2
Interface GigabitEthernet2/0/4 VLAN 1
MEP ID: 9 Level: 6 Service instance: 6 Direction: Outbound
Maintenance domain: mdtest6
Maintenance association: matest6