3Com S7902E Command Reference Manual - page 810
1-11
Priority : L1 64 L2 64
Retransmit Timer Value : L12 5
Retransmit-Throttle Timer : L12 33
BFD : Disabled
Tunnel L1 State : OFF
Tunnel L2 State : ON
Tunnel Type : AA
Tunnel Metric : 0
Destination Router ID : 5.5.5.5
Table 1-3
display isis interface
command output description
Field
Description
Interface
Interface type and number
Id Circuit
ID
IPV4.State IPv4
state
IPV6.State IPv6
state
MTU Interface
MTU
Type
Interface link adjacency type
DIS
Whether the interface is elected as the DIS or not
SNPA Address
Subnet access point address
IP Address
Primary IP address
Secondary IP Address(es)
Secondary IP addresses
IPV6 Link Local Address
IPv6 link local address
IPV6 Global Address(es)
IPv6 global address
Csnp Timer Value
Interval for sending CSNP packets
Hello Timer Value
Interval for sending Hello packets
Hello Multiplier Value
Number of invalid Hello packets
Lsp Timer Value
Minimum interval for sending LSP packets
Cost
Cost of the interface
Priority DIS
priority
Retransmit Timer Value
LSP retransmission interval over the point-to-point link
BFD
Whether BFD is enabled on the interface
MPLS TE Status
Whether MPLS TE is enabled on the interface
INTF L1 TE Status
Whether level-1 MPLS TE is enabled on the interface
INTF L2 TE Status
Whether level-2 MPLS TE is enabled on the interface
TE Cost
MPLS TE cost configured on the interface
TE Admin Group
TE link administration group
TE Max Bandwidth
TE link maximum bandwidth
TE Max Res Bandwidth
TE link maximum reserved bandwidth
Tunnel L1 State
IS-IS TE tunnel level-1 state