3Com S7902E Command Reference Manual - page 709
1-9
Peer Aging Permanent Garbage
21.0.0.23 2 0 3
21.0.0.12 2 0 4
Total 4 0 7
Table 1-5
display rip route statistics command output description
Field
Description
Peer
IP address of a neighbor
Aging
Total number of aging routes learned from the specified neighbor
Permanent
Total number of permanent routes learned from the specified neighbor
Garbage
Total number of routes in the garbage-collection state learned from the
specified neighbor
Total
Total number of routes learned from all RIP neighbors
filter-policy export (RIP view)
Syntax
filter-policy
{
acl-number
|
ip-prefix
ip-prefix-name
}
export
[
protocol
[
process-id
] |
interface-type
interface-number
]
undo filter-policy
export
[
protocol
[
process-id
] |
interface-type interface-number
]
View
RIP view
Default Level
2: System level
Parameters
acl-number
: Number of an ACL used to filter outbound routes, in the range of 2000 to 3999.
ip-prefix ip-prefix-name
: Name of an IP prefix list used to filter outbound routes, a string of 1 to 19
characters.
protocol
: Filters outbound routes redistributed from a specified routing protocol, which can be
bgp
,
direct
,
isis
,
ospf
,
rip
, and
static
.
process-id
: Process ID of the specified routing protocol, in the range of 1 to 65535. You need to specify
a process ID when the routing protocol is
rip
,
ospf
, or
isis
.
interface-type interface-number
: Specifies an interface.
Description
Use the
filter-policy
export
command to configure the filtering of RIP outgoing routes. Only routes not
filtered out can be advertised.
Use the
undo filter-policy
export
command to remove the filtering.
By default, RIP does not filter outbound routes.
Note that: