3Com S7902E Command Reference Manual - Configuration Commands
1-1
1
IPv6 Multicast Routing and Forwarding
Configuration Commands
The term “router” in this document refers to a router in a generic sense or a Layer 3 switch running an IP
multicast routing protocol.
IPv6 Multicast Routing and Forwarding Configuration Commands
display multicast ipv6 boundary
Syntax
display multicast ipv6 boundary
[
ipv6-group-address
[
prefix-length
] ] [
interface interface-type
interface-number
]
View
Any view
Default Level
1: Monitor level
Parameters
ipv6-group-address
: IPv6 multicast group address, in the range of FFxy::/16, where x and y represent
any hexadecimal number from 0 through F.
prefix-length
: Prefix length of an IPv6 multicast group address, in the range of 8 to 128. The system
default is 128.
interface-type interface-number
: Specifies an interface by its type and number.
Description
Use the
display multicast ipv6 boundary
command to display the IPv6 multicast boundary
information on the specified interface or all interfaces.
Related commands:
multicast ipv6 boundary
.
Examples
# Display the IPv6 multicast boundary information configured on all interfaces.