3Com S7902E Command Reference Manual - page 423
1-12
region-name
Syntax
region-name
name
undo region-name
View
MST region view
Default Level
2: System level
Parameters
name
: MST region name, a string of 1 to 32 characters.
Description
Use the
region-name
command to configure the MST region name of your device.
Use the
undo region-name
command to restore the default MST region name.
By default, the MST region name of a device is its MAC address.
The MST region name, the VLAN-to-MSTI mapping table and the MSTP revision level of a device jointly
determine the MST region the device belongs to.
Related commands:
instance
,
revision-level
,
check region-configuration
,
vlan-mapping modulo
,
active region-configuration
.
Examples
# Set the MST region name of the device to “hello”.
[Sysname] stp region-configuration
[Sysname-mst-region] region-name hello
reset stp
Syntax
reset stp
[
interface
interface-list
]
View
User view
Default Level
1: Monitor level
Parameters
interface interface-list
: Specifies an Ethernet port list, in the format of
interface-list
= {
interface-type
interface-number
[
to
interface-type interface-number
] }&, where & indicates that you
can specify up to 10 ports or port ranges.